Fujitsu M10-4 Service Manual page 188

Hypervisor : 0.21.3
XSCF : 02.01.0001
CMU BACKUP
#0: 02.01.0001
#1: ..
XSCF>
5.
Execute the showlogs command to confirm that the system is operating
normally.
XSCF> showlogs error
For details, see
6.
Execute the testsb command to confirm that the CPU memory unit requiring
maintenance is normally recognized.
For a building block configuration, you do not have to execute the testsb
command. Proceed to step 7.
When you add the "-y" option to the testsb command, the system automatically
answers "y" (yes) in response to an inquiry.
The following example shows the diagnosis of system board 00-0.
XSCF> testsb -v -y -s 00-0
7.
Execute the showstatus command to confirm that the CPU memory unit is
operating normally after maintenance.
If there is no problem, nothing is displayed.
XSCF> showstatus
8.
Execute the showhardconf command to check the hardware configuration
and the status of each component.
Confirm that no asterisk (*) is displayed in front of each component.
XSCF> showhardconf
9.
Execute the showdate command to confirm the XSCF time.
There is no need to set the time if the NTP server is set to the XSCF. Proceed to
step 11.
XSCF> showdate
10. If the XSCF time is different from the current time, execute the setdate
command to set the time.
Specify the time in either of the following formats:
Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual ･ February 2014
164
"3.3.5 Checking log information."