Chapter 6 Understanding The Preparations For Restoring The System; Incorporating An Fru Into The System With The Replacefru Command; Incorporating An Fru Of The Sparc M10-4/M10-4S Into The - Fujitsu M10-4 Service Manual

Chapter 6
Understanding the Preparations for
Restoring the System
This chapter describes the procedures required to restore the system after component
maintenance. See this chapter, as required, when performing maintenance on each
component described in Chapter 7 onwards.

Incorporating an FRU into the System with the replacefru Command

■
Incorporating a Chassis into a Physical Partition
■
Powering On the Physical Partition Requiring Maintenance
■
Starting the Entire System
■
Restoring the Chassis
■
6.1 Incorporating an FRU into the System
with the replacefru Command
This section describes the procedure for incorporating an FRU into the system after
maintenance. To do this, resume the replacefru command, which is running, to
incorporate the FRU into the system.
6.1.1 Incorporating an FRU of the SPARC M10-4/M10-
4S into the system
If the maintenance target is the SPARC M10-4/M10-4S, the following are targeted as
FRUs:
Chassis of the SPARC M10-4/M10-4S
■
Power supply unit of the SPARC M10-4/M10-4S
■
Fan unit of the SPARC M10-4/M10-4S
■
1.
After completing maintenance of the target FRU, return to the replacefru
command operation of the XSCF firmware, and enter "f".
71