Restoring The System; For Windows Server 2008 - Fujitsu PRIMERGY BX620 S4 User Manual

Chapter 9 Operation and Maintenance

9.6 Restoring the system

If the system is damaged, use the backup data created after the installation to restore
the system.
Backup data for system recovery must be created in advance. For the procedure for creating it, refer to
"5.2 Creating Backup Data for System Recovery" ( pg.107).
When using the backup device, refer to the manual provided with the backup device or Readme.txt
included in the device driver.

9.6.1 For Windows Server 2008

The whole server can be restored using the Windows Server Backup function.
Items required
• Windows Server 2008 DVD-ROM (Installation disc)
• Backup data created using the Windows Server Backup function (connectable shared folder, DVD,
etc.)
1
Insert the Windows Server 2008 DVD-ROM (Installation disc) immediately after
turning on the server.
Check that there is not already a floppy disk inserted in the floppy disk drive at this time.
2
When active area is specified on the hard disk, the following message is
displayed on the bottom of the window. Press any key while the message is
displayed.
Press any key to boot ...
The Windows Server 2008 setup window appears.
254