Mitsubishi Electric FR-E700 Instruction Manual page 8

Additional Instructions
Also note the following points to prevent an accidental failure, injury, electric shock, etc.
Transport and Installation
E
CAUTION:
● Any person who is opening a package using a sharp object, such as a knife and cutter, must
wear gloves to prevent injuries caused by the edge of the sharp object.
● Transport the product using the correct method that corresponds to the weight. Failure to
observe this could lead to injuries.
● Do not stack the inverter boxes higher than the number recommended.
● Ensure that installation position and material can withstand the weight of the inverter.
Install according to the information in the instruction manual.
● Do not install the product on a hot surface.
● The inverter must be installed on a strong surface securely with screws so that it will not drop.
● Do not install or operate the inverter if it is damaged or has parts missing. This can result in
breakdowns.
● When carrying the inverter, do not hold it by the front cover or setting dial; it may fall off or
fail.
● During installation, caution must be taken not to drop the inverter as doing so may cause
injuries.
● Do not stand or rest heavy objects on the product.
● Check the inverter mounting orientation is correct.
● Prevent other conductive bodies such as screws and metal fragments or other flammable
substance such as oil from entering the inverter.
● As the inverter is a precision instrument, do not drop or subject it to impact.
● If halogen-based materials (fluorine, chlorine, bromine, iodine, etc.) infiltrate into a
Mitsubishi Electric product, the product will be damaged. Halogen-based materials are
often included in fumigant, which is used to sterilize or disinfect wooden packages. When
packaging, prevent residual fumigant components from being infiltrated into Mitsubishi
Electric products, or use an alternative sterilization or disinfection method (heat disinfec-
tion, etc.) for packaging. Sterilization of disinfection of wooden package should also be
performed before packaging the product.
● Use the inverter under the following environmental conditions. Otherwise, the inverter may
be damaged.
Operating Condition
Ambient temperature
Ambient humidity
Storage temperature
Atmosphere
Altitude
Vibration
Temperature applicable for a short time, e.g. in transit.
IV
Specifications
10 °C to +50 °C (non-freezing)
90 % RH or less (non-condensing)
20 °C to +65 °C
Indoors (free from corrosive gas, flammable gas, oil mist, dust and dirt)
Maximum 1000m above sea level for standard operation.
After that derate by 3% for every extra 500 m up to 2500 m (91%)
5.9 m/s² or less at 10 to 55 Hz (directions of X, Y, Z axes)