Operation Mode Selection Pr; Operation Mode At Power On Pr. 79, Pr - Mitsubishi Electric FR-E700 Instruction Manual

Parameter
Operation mode basics
The operation mode is to specify the source of inputting the start command and set frequency of the
inverter.
● Select the "external operation mode" when performing operation by basically using the control
circuit terminals and providing potentiometers, switches, etc. externally.
● Select the "PU operation mode" when inputting the start command and frequency setting
through communication from the operation panel, parameter unit (FR-PU04/FR-PU07) or PU
connector.
● Select the "network operation mode (NET operation mode)" when the commands are applied
from the RS-485 communication with the PU connector or the network to the communication
option card.
The operation mode can be selected from the operation panel or with the communication instruction
code.
GOT
Fig. 6-102: Operation modes of the inverter
NOTES Either "3" or "4" may be set to select the PU/external combined mode.
The stop function (PU stop selection) activated by pressing the STOP/RESET key of the operation
panel and parameter unit (FR-PU04/FR-PU07) is valid even in other than the PU operation mode in
the initial setting. (Refer to Pr. 75 "Reset selection/disconnected PU detection/PU stop selection"
(section 6.17.1).)
FR-E700 SC EC/ENE
PU operation
mode
FR-PU07
Network
operation mode
Personal computer
PLC
Selection of operation mode and operation location
PU operation mode
Inverter
USB connector
PU operation mode
Operation panel
PU connector
Communication
option
External terminals
Potentiometer
External
operation
mode
Switch
I001823E
6 - 207