Mitsubishi Electric FR-E700 Instruction Manual page 370

Selection of operation mode and operation location
Switching of operation mode by external terminal (X65, X66)
When Pr. 79 = any of "0, 2, 6", the operation mode switching signals (X65, X66) can be used to change
the PU or external operation mode to network operation mode during a stop (during a motor stop or
start command off). (Pr. 79 = "6" switch-over mode can be changed during operation)
When switching between the network operation mode and PU operation mode:
Set Pr. 79 to "0" (initial value) or "6".
Set "10" in Pr. 340 "Communication start-up mode selection".
Set "65" to any of Pr. 178 to Pr. 184 to assign the PU-NET operation switching signal (X65) to the
external terminal.
The operation mode changes to PU operation mode when the X65 signal turns on, or to network
operation mode when the X65 signal turns off.
Pr. 340
10
Tab. 6-58: Operation mode switching by signal X65
NET operation mode when the X66 signal is on.
PU operation mode is selected when the X16 signal is off. PU operation mode also when Pr. 550
"NET mode operation command source selection" = 0 (communication option control source) and
the communication option is not fitted.
External operation mode when the X16 signal is on.
6 - 216
Pr. 79
ON (PU)
PU operation
0
(initial setting)
mode
1
2
3 / 4 External/PU combined operation mode
PU operation
6
mode
Switching among the External and PU op-
X12 (MRS) ON
eration mode is enabled
7
X12 (MRS) OFF External operation mode
X65 Signal State
OFF (NET)
NET operation
mode
PU operation mode
NET operation mode
NET operation
mode
Remarks
Fixed to PU operation mode
Fixed to NET operation mode
External/PU combined mode fixed
Operation mode can be switched with
operation continued
Output stop in external operation mode
Forcibly switched to external operation
mode
Parameter