Mitsubishi Electric FR-E700 Instruction Manual page 378

Selection of operation mode and operation location
Oper-
ation Condition
Command
Loca- (Pr. 551)
tion
Run command
(start, stop)
Running frequency
setting
—
Parameter write
Inverter reset
Inverter reset
Run command
—
(start, stop)
Running frequency
setting
Tab. 6-62: Functions in the single operation modes (2)
✔: enabled
—: not enabled
: some are enabled
As set in Pr. 338 "Communication operation command source" and Pr. 339 "Communication
speed command source".
At occurrence of RS-485 communication error, the inverter cannot be reset from the computer.
Enabled only when stopped by the PU. At a PU stop, "PS" is displayed on the operation panel. As
set in Pr. 75 "Reset selection/disconnected PU detection/PU stop selection". (Refer to section
6.17.1.)
Some parameters may be write-disabled according to the Pr. 77 "Parameter write selection"
setting and operating status. (Refer to section 6.17.2).
Some parameters are write-enabled independently of the operation mode and command source
presence/absence. When Pr. 77 = 2, write is enabled. (Refer to Tab. 6-1 for the parameter list.)
Parameter clear is disabled.
FR-E700 SC EC: When Pr. 550 "NET mode operation command source selection" = 2 (PU connector
valid) or Pr. 550 "NET mode operation command source selection" = 9999 and the communication
option is not fitted.
FR-E700 SC ENE: When Pr. 550 NET mode operation command source selection = "2" (PU connector
valid)
FR-E700 SC EC: When Pr. 550 "NET mode operation command source selection" = 0 (communica-
tion option valid) or Pr. 550 "NET mode operation command source selection" = 9999 and the
communication option is fitted.
FR-E700 SC ENE: When Pr. 550 NET mode operation command source selection = "0" (Ethernet
connector valid)
6 - 224
External
PU Operation
Operation
— —
— —
— —
— —
✔ ✔
✔
—
✔
—
Operation Mode
External/PU External/PU
Combined Combined
Operation Operation
Mode 1 Mode 2
(Pr. 79 = 3) (Pr. 79 = 4)
— —
— —
— —
— —
✔ ✔
✔
—
✔
—
Parameter
NET Operation
(FR-E700 SC EC:
When Commu-
NET Operation
nication Option
(When Using
PU
is used) /
Ethernet con-
Connector)
nector (FR-
E700 SC ENE)
✔
—
✔
—
✔
—
✔
—
✔
—
—