Set Redundant Switch Mode - 3Com CoreBuilder 7000 Management Manual

C 3: G
66
HAPTER ENERAL
Set Redundant
Switch Mode
T
ASKS
Enter parameter(s): 0-Enhanced redund. 1-Basic redund.
Enter 0 to specify enhanced redundancy.
The following message appears:
Full redundancy mode invoked.
If you are unable to configure enhanced mode because of incorrect
modules in the chassis, this message appears:
No proper IFC is populated.
For more information on allowed module types for enhanced
redundancy, see Chapter 10 in the Operations Guide.
Sets the redundant switch mode.
Command Actions
Enter the menu sequence: (1) SYS: Platform config
Enter a parameter at the prompt
Parameter
Redundant switch mode 0 - Standby
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 13 3
The following prompt is displayed:
Enter parameter(s): 0-Standby 1-Suspended
Enter 0 to specify standby mode for the redundant switch.
(1) SET: Switch setup
(13) SRS: Switch Redundancy setup
(3) SSM: Set redundant switch mode
Format
1 - Suspended
1 1 13 3 [parameter]
The redundant switch mode is set.
Standby mode is invoked.