Remove Vp Tunnel From Port - 3Com CoreBuilder 7000 Management Manual

C 7: C
230
HAPTER ONFIGURING
Remove VP Tunnel
from Port
V C
IRTUAL HANNELS
Removes a VP tunnel from a port of the CoreBuilder 7000 family ATM
switch. Specify the port and VPI number. For more information, see "VP
Tunneling" on page 5-101.
Command Actions
Enter the menu sequence: (1) SYS: Platform config
Enter a parameter at the prompt
Parameter
Port ID
VPI Value
Direct access sequence:
Command Result
System action taken:
System message display:
See Table 34 for definitions of the command parameters.
Example
Enter:
1 1 9 3 3 3.2 3
The following message is displayed:
Tunnel is set to DISABLED.
The VP tunnel with VPI=3 is removed from port 3.2.
(1) SET: Switch setup
(9) VPT: VP Tunneling Setup
(3) TUN: Tunnels Setup
(3) DTN: Disable Tunnel on Port
Format or Range
slot.port
0 through 7
1 1 9 3 3 [parameters]
A VP tunnel is removed from a port. The change takes
place immediately.
Tunnel is set to DISABLED.