Enable Vp Tunneling Mode - 3Com CoreBuilder 7000 Management Manual

C 7: C
222
HAPTER ONFIGURING
Enable VP Tunneling
Mode
V C
IRTUAL HANNELS
Enables the VP tunneling mode of the CoreBuilder 7000 family ATM
switch. The mode can be enabled or disabled. VP tunnels can only be
configured if the VP tunneling mode is enabled. For more information,
see "VP Tunneling" on page 5-101.
VP Tunneling mode will be enabled only after the next reboot.
Command Actions
Enter the menu sequence: (1) SYS: Platform config
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 9 1 2
The following message is displayed:
VP TUNNELING mode will be enabled for the next reboot.
(1) SET: Switch setup
(9) VPT: VP Tunneling Setup
(1) MOD: VP Tunneling Mode Setup
(2) EVP: Enable VP Tunneling Mode
1 1 9 1 2
The VP Tunneling Mode of the CoreBuilder 7000
family ATM switch is enabled. The change will take
place after the next reboot.
VP TUNNELING mode will be enabled for
the next reboot.