Set Aggregation Token - 3Com CoreBuilder 7000 Management Manual

Set Aggregation
Token
Sets the aggregation token. The aggregation token is a number assigned
to an outside link by the border nodes.
This option is currently not supported in this version.
Command Actions
Enter menu sequence:
Enter a parameter at the prompt
Parameter
aggregation token
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 10 4 4 2 1 50
The following message is displayed:
Default value is 0, new value is set to 50
Press ENTER to continue...
Setting Interface Parameters
(1) SYS: Platform config
(1) SET: Switch setup
(10) PNI: PNNI Setup
(4) CFP: Configure PNNI
(4) ICF: Interface Configuration
(2) IPR: Interface Parameters
(1) AGT: Aggregation Token
Format or Range
1 - 2147483647
1 1 10 4 4 2 1 [parameters]
The aggregation token is updated to its new value.
Default value is 0, new value is set to
<n>
425