Display Oc-3 Interface Module Info - 3Com CoreBuilder 7000 Management Manual

C 5: C
116
HAPTER ONFIGURING
Display OC-3
Interface Module
Info
I M
NTERFACE ODULES
Reads manufacturing information of a selected interface module. You are
prompted to specify a port. This command is applicable to the 8-Port
Board ATM Interface Module only.
Command Actions
Enter the menu sequence: (1) SYS: Platform config
Enter a parameter at the prompt
Parameter
Port ID
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 5 1 6 3.4
Manufacturing information of the selected interface module in port 3.4
of interface card #1, an 8-Port Board ATM interface card, is displayed:
(5) IFC: Interface cards
(n) IFn; (n=1,4)
(6) RSE: Read IFC technical data
(8 Port only)
Format or Range
slot.port
1 5 n 6 [parameters]
Manufacturing information of the selected interface is
displayed.
Information is displayed as shown in the example.