Display Ptse Node Information - 3Com CoreBuilder 7000 Management Manual

Display PTSE Node
Information
Displays PTSE information for each node stored in the topology database.
Command Actions
Enter menu sequence:
Direct access sequence:
Command Result
System action taken:
System message display:
Node PTSE Table Parameters
For a full description of all the parameters displayed in the node
information table, see Table 58: PTSE Table Parameters - PTSE Section.
Example
Enter:
1 1 10 4 7 2
The following information is displayed:
Showing PNNI Information
(1) SYS: Platform config
(1) SET: Switch setup
(10) PNI: PNNI Setup
(4) CFP: Configure PNNI
(7) SHO: Show PNNI information
(2) NOD: Node PTSEs
1 1 10 4 7 2
All PTSE information for each node stored in the
database is displayed.
Information is displayed as shown in the example.
451