Direct Access To Submenus; Entering Multiple Parameters; Quick Key Functions - 3Com CoreBuilder 7000 Management Manual

C 2: U
40
HAPTER SING THE
Direct Access to
Submenus
Entering Multiple
Parameters

Quick Key Functions

L M A
OCAL ANAGEMENT PPLICATION
6 At the
Enter the new read password again:
password again exactly as before.
Command Results
After the command executes successfully, a system message is displayed:
The password has been changed.
The command results and systems messages are shown in the last rows of
the command description in Figure 1 .
You can display a menu or execute a command directly, without having to
step down through the hierarchy as in the previous example. At the Main
Menu prompt, type the required sequence of menu item numbers, or
menu item mnemonics, followed by the command parameters all on one
line, separated by blanks. To display the password prompt directly from
the Main Menu for the example of the previous section, just type
at the Main Menu prompt. The direct access menu sequence is included
in the command description format shown in Figure 1 .
When a command has more than one parameter, you can enter them all
on the same command line separated by blanks or you can enter some or
all of them on separate command lines. If you do not enter them all on
one line, you are repeatedly prompted for the remaining parameters.
Should you enter an illegal character or string (such as an out-of-range
parameter), an error message is displayed.
The following quick key functions are available when working with the
management menus. Table 8 describes functions for navigating in the
menu system; Table 9 describes aids for editing parameters.
Table 8 Menu Navigation Functions
To go
To Main Menu from any point
To previous menu
Back and forth within the command line
To beginning of the command line
To end of the command line
prompt, enter the new
1 1 1 1
Type
\
-
Left/Right Arrows
Home
End