Ifc Communications Statistics; Display Ifc Communications Statistics - 3Com CoreBuilder 7000 Management Manual

C 8: V
250
HAPTER IEWING
IFC
Communications
Statistics
Display IFC
Communications
Statistics
S
TATISTICS
The following commands allow you to display IFC communications
statistics.

Display IFC Communications Statistics

Reset IFC Communications Statistics
Displays the IFC Communications statistics, including protocol
information, for a specified port.
ICP is the main communications protocol used between the switch and its
installed interface cards. Two physical layer protocols are used, I9 and
ALC. The I9 protocol is used for the transputers on the 4-Port, 8-Port, 622
Carrier and CoreBuilder 7200 Cards; the ALC protocol is used for the
CoreBuilder 7200, 7400, 7600 and FastBUS cards.
Note that there are no statistics for ALC.
Command Actions
Enter the menu sequence: (4) STS: Statistics
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
4 7
The IFC communications statistics parameters for the switch is displayed.
(7) COM: IFC Communications Statistics
4 7
IFC Communications statistics for IF cards are
displayed.
Information is displayed as shown in the example
below.