3Com CoreBuilder 7000 Management Manual page 124

C 5: C
124
HAPTER ONFIGURING
I M
NTERFACE ODULES
Command Actions
Enter the menu sequence: (1) SYS: Platform config
Enter a parameter at the prompt
Parameter
Port ID
Port Interface type
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 3 4 3.2 1
The following message is displayed:
NNI type was set.
The interface type for port <3.2> is updated to UNI.
(1) SET: Switch setup
(3) NNI: NNI setup
(4) SIF: NNI set&save interface type
Format or Range
slot.port (0.0 for all ports)
0 to set interface type to E-IISP
1 to set interface type to UNI
2 to set interface type to IISP
3 to set interface type to PNNI
1 1 3 4 [parameters]
The interface type for the specified port is updated.
NNI type was set.