Disable Port For Vp Tunneling - 3Com CoreBuilder 7000 Management Manual

C 7: C
226
HAPTER ONFIGURING
Disable Port for VP
Tunneling
V C
IRTUAL HANNELS
Disables a port of the CoreBuilder 7000 family ATM switch for VP
Tunneling. A port can be enabled or disabled. VP tunnels can be
configured only if VP tunneling is enabled for the port. Once a port is
disabled for VP tunneling it can be used as an ordinary port. For more
information, see "VP Tunneling" on page 5-101.
Command Actions
Enter the menu sequence: (1) SYS: Platform config
Enter a parameter at the prompt
Parameter
Port ID
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 9 2 3 4.1
The following message is displayed:
Port <4.1> is no longer tunnel port.
(1) SET: Switch setup
(9) VPT: VP Tunneling Setup
(2) TPS: VP Tunneling Ports Setup
(3) RTP: Remove VP Tunneling Port
Format or Range
slot.port
1 1 9 2 3 [parameters]
The port is disabled for VP Tunneling. The change
takes place immediately.
Port <slot.port> is no longer tunnel
port.