Reset Pnni Interface Parameters To Default Values - 3Com CoreBuilder 7000 Management Manual

C 13: C
432
HAPTER ONFIGURING AND
Reset PNNI Interface
Parameters to Default
Values
M PNNI (F
ANAGING
Resets all the PNNI interface parameters for the specified interface port
(as selected in the Select Port option) to their default values. The
parameter reset takes place immediately. See "Select Port for Interface
Parameter Setting" on page 423 for details.
Command Actions
Enter menu sequence:
Enter a parameter at the prompt
Parameter
Confirm reset
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 10 4 4 2 7 y
The following message is displayed:
Interface parameters were set to their defaults
Press ENTER to continue...
E V O
OR THE XTENDED ERSION
(1) SYS: Platform config
(1) SET: Switch setup
(10) PNI: PNNI Setup
(4) CFP: Configure PNNI
(4) ICF: Interface Configuration
(2) IPR: Interface Parameters
(8) SDF: Set to Defaults
Format or Range
y or n
1 1 10 4 4 2 8
The interface parameters for the specified port are set
to their default values.
Interface parameters were set to their
defaults.
)
NLY