Ilmi Atm Addresses; Display Ime Atm Addresses At Port - 3Com CoreBuilder 7000 Management Manual

ILMI ATM Addresses

Display IME ATM
Addresses at Port
The following commands allow you to configure the ILMI ATM addresses.

Display IME ATM Addresses at Port

Display Static ATM Addresses at Port
Display De-registered ATM Addresses at Port
Add ATM Address to Port
Delete ATM Address from Port
Save ATM Addresses to Flash
Erase ATM Addresses from Flash
Displays UNI Management Entities (IME) registered ATM addresses for
specified ports of the switch. These ATM addresses were registered by
end stations or edge devices attached to the port using the ILMI address
registration process. For more information, "UNI Address Registration"
on page 38 in the Operations Guide.
Addresses defined through LMA are not displayed by this command.
For easy reference, each ATM address registered at a port is assigned a
member ID . The member ID is made up of the <slot.port> number
followed by a two-digit number of the form 0n where 01 corresponds to
the first ATM address registered, 02 to the second and so on. For
example, the member ID for the first ATM address registered at port
<3.3> is 3301.
The member ID is useful for displaying information about calls which are
associated with the ATM address. For example, if a switched virtual
channel is established through to the LEC whose ATM address is
registered at the port, you use the member ID to reference that virtual
channel in order to display information about calls to the LEC on that
channel. For more information, see "Display Call Routed to ATM
Address" on page 165.
ILMI ATM Addresses 151