Default Users And Passwords - 3Com 4500G Series Getting Started Manual

Default Users and
Passwords
can do this using the command line interface system management snmp
community command. Refer to the command line interface section of the
"SuperStack 4 Switch Command Reference Guide" for more information.
SNMP V3 is on as default. All commands are in snmp menu in System View.
If you intend to manage the switch using the web interface or the command line
interface, or to change the default passwords, you need to log in with a valid user
name and password. The switch has three default user names, and each user
name has a different password and level of access. These default users are listed in
Table 11.
CAUTION: To protect your switch from unauthorized access, you must change all
three default passwords as soon as possible, even if you do not intend to actively
manage your switch.
Table 11 Default Users
User Default
Name Password
monitor monitor
manager manager
admin (no
password)
Use the admin default user name (no password) to login and carry out initial
switch setup.
To set a password for the admin user in the CLI, enter the following from system
view:
[4500G]local-user admin <cr>
[4500G-luser-admin]password simple xxxxxxxx
(where xxxxxxxx is your chosen password).
Save the configuration in the User View.
For information on the lost password procedure please refer to the Configuration
Guide that is supplied with your switch.
Access Level
monitor
The user can view all manageable parameters, except
special/security features, but cannot change any
manageable parameters
manager
The user can access and change the operational parameters
but not special/security features
security
The user can access and change all manageable parameters

Default Users and Passwords

47