8-Port Gigabit Ethernet Sfp Xpim Components - Juniper SRX Series Manual

RELATED DOCUMENTATION
8-Port Gigabit Ethernet SFP XPIM Hardware Specifications | 95
8-Port Gigabit Ethernet SFP XPIM Network Interface Specifications | 26
8-Port Gigabit Ethernet SFP XPIM Supported Modules | 97
8-Port Gigabit Ethernet SFP XPIM Key Features | 94
8-Port Gigabit Ethernet SFP XPIM LEDs | 96

8-Port Gigabit Ethernet SFP XPIM Components | 93

8-Port Gigabit Ethernet SFP XPIM Basic Configuration | 221
8-Port Gigabit Ethernet SFP XPIM Components
The 8-Port Gigabit Ethernet small form-factor pluggable Gigabit-Backplane Physical Interface Module
(SFP XPIM) contains the components listed in
Table 47: 8-Port Gigabit Ethernet SFP XPIM Components
Component
ONLINE/OFFLINE button
TX and RX coaxial connectors
Two captive screws
RELATED DOCUMENTATION
8-Port Gigabit Ethernet SFP XPIM Overview | 92
8-Port Gigabit Ethernet SFP XPIM Hardware Specifications | 95
Table 47 on page
Location
Right side of the XPIM
Middle/right of the XPIM
One on each side of the
XPIM
93.
Description
Use the ONLINE/OFFLINE button to gracefully
shut down the XPIM. Press down and hold the
button for 4 to 5 seconds; then release. The XPIM
gracefully shuts down and turns off the power
supply units (PSUs).
To power up the XPIM (if the Services and Routing
Engine [SRE] is off), press and hold the
ONLINE/OFFLINE button for 4 to 5 seconds.
Dual 75-ohm BNC coaxial socket connectors: TX
(transmit) and RX (receive).
Use the captive screws to hold the XPIM in place.
93