Table of Contents
Advertisement
COMBINATION: Page Menu Commands
Compare
Write Combination
Exclusive Solo
Copy From Program
Add To Set List
Load required samples
Edit Program
Initialize Combination
Optimize RAM
Select Sample No.
Select Directory/File for Sample To Disk
Auto Sampling Setup
Copy Tone Adjust
Reset Tone Adjust
Show EQ Graphic
Copy X-Y Envelope
Detune BPM Adjust
Copy External Scene
Copy Scene
Swap Scene
Initialize Scene
Copy Insert Effect
Swap Insert Effect
Insert IFX Slot
Clean Up IFX Routings
Drum Kit IFX Patch
Copy MFX/TFX
Swap MFX/TFX
Write FX Preset
PAGE
MODE
Write Combination
This command writes an edited Combination into the
NAUTILUS internal memory. It is available on every page
in COMBINATION mode.
This lets you:
• Save your edits
• Rename the Combination
• Assign the Combination to a Category
• Mark the Combination as a Favorite
• Copy the Combination to a different Bank and number
Be sure to Write any Combination that you wish to save. An
edited Combination cannot be recovered if you do not write
it before turning off the power or selecting another
Combination.
Do not turn off the power for at least 10 seconds after
using the Write Combination command. This allows the
system time to complete the process, which includes
saving a backup of the data to the internal drive.
For more information, please see "Write Program" on
page 112.
COMBINATION: Page Menu Commands Write Combination
→p.112
→p.433
→p.113
→p.433
→p.113
→p.114
→p.434
→p.435
→p.114
→p.115
→p.115
If you use "Category" or 'Sub Category" to specify a
→p.116
category for the combination you are writing, you will be
→p.436
able to select that combination by its category or sub
→p.436
category in COMBINATION > Home.
→p.436
The names of the combination categories can be edited in
→p.119
"Combi Category" (GLOBAL 3–2).
→p.437
→p.121
Exclusive Solo
→p.121
→p.122
This command is available on every page in
→p.122
COMBINATION mode. When Exclusive Solo is On, only
→p.122
one Timbre is soloed at a time; when it is Off, multiple
→p.122
Timbres can be soloed together.
→p.122
For more information, please see "Exclusive Solo" on
→p.124
page 113.
→p.437
→p.125
Copy From Program
→p.125
→p.125
This command is available on every page in
→p.126
COMBINATION mode. It copies Effects and/or ARP
→p.126
settings from a selected Program to the current Combination.
This lets the Program sound the same as it did in
PROGRAM mode.
1. Select "Copy From Program" to open the dialog box.
2. Use "Program" to select the copy-source program.
3. Select the IFX-All, IFX-All used, MFXs, and TFXs
options to specify which, if any, of the Program's
effects settings to copy.
IFX-All: The settings of all insert effect settings (the
contents of the Insert FX page and the IFX1–12 effect
parameters) of the copy-source program will be copied.
IFX-All used: Only the insert effects used by the copy-
source program will be copied. The copied settings will
be packed into vacant slots (i.e., slots with 000: No
Effect, unless such slots are located inside the chain).
433
Advertisement
Table of Contents
