063: Stereo Auto Pan - Korg NAUTILUS Series Parameter Manual

063: Stereo Auto Pan

Stereo In - Stereo Out
Left
Right
LFO: Tri / Sin LFO Shape
This is a stereo-in, stereo-out auto-panner. The Phase and
Shape parameters lets you create various panning effects,
such as making the left and right inputs seem to chase each
other around the stereo field.
AUTO PAN
Depth
Sets the depth of LFO modulation.
Source
Selects the modulation source of the depth of modulation.
Amount
Sets the modulation amount of the depth of modulation.
LFO
Waveform
Selects the LFO Waveform.
Shape
This changes the curvature of the LFO Waveform, which
controls the way that the audio moves around the stereo
field.
Phase [degrees]
This determines the phase difference between the left and
right LFOs. When you gradually change the value away
from 0, the sounds from the left and right channels will seem
to chase each other around. If you set the parameter to +180
or –180, the sounds from each channel will cross over each
other.
You'll only hear the effect of this parameter if the input is
true stereo, with different signals in the left and right
channels.
LFO Phase = 0 degrees LFO Phase = 90 degrees
L-In
R-In
L-In
R-In
L-In L-In
R-In
L-In
R-In R-In
L-In
R-In
Left Right
Center
Output Stereo Image
Wet / Dry
Pan
Depth
Pan
Wet / Dry
LFO Phase
[0...100]
[Off...Tempo]
[+/–100]
[Triangle, Sine]
[+/–100]
[–180...+180]
Stereo Auto Pan - LFO Phase
LFO Phase = 180 degrees
L-In L-In
R-In R-In
L-In
L-In
R-In
R-In
L-In
R-In
R-In
L-In
L-In
R-In
L-In L-In
R-In R-In
Modulation and Pitch Shift 063: Stereo Auto Pan
Frequency [Hz]
This sets the LFO speed, in Hz. It applies only when
MIDI/Tempo Sync, below, is Off.
Source
This selects a modulation source for the Frequency.
Amount
This sets the Frequency modulation amount, in Hz.
MIDI/Tempo Sync
BPM
Base Note
Times
When MIDI/Tempo Sync is on, the LFO speed is set by
BPM, Base Note, and Times, instead of Frequency. For
more information, see "MIDI/Tempo Sync" on page 779.
Type [Individual, Common1, Common2]
This controls whether the effect uses its individual LFO, or
one of the Common FX LFOs. For more information, see
"LFO Type" on page 779.
Common LFO Phase Offset [degrees]
When Type is set to Common FX LFO 1 or 2, this lets you
offset the phase from the master LFO.
OUTPUT
This is the standard effects output section, with modulatable
control over wet/dry balance. For more information, see
"OUTPUT" on page 762.
[0.02...20.00]
[Off...Tempo]
[–20.00...+20.00]
[Check-box]
[MIDI, 40.00...300.00]
[ ... ]
[x1...x32]
[+/–180]
819