8-9: Common Fx Lfo - Korg NAUTILUS Series Parameter Manual

8–9: Common FX LFO
1–1a
8–9a
8–9b
The two Common FX LFOs allow you to synchronize LFO-
based modulation for multiple effects, such as phasers,
flangers, filters, and so on.
The Common LFOs control only the frequency, MIDI
synchronization, and reset options; each individual effect
still has its own settings for the LFO waveform and phase.
Within the individual effects, you can choose whether to use
one of the Common LFOs, or to use the individual effect's
frequency, sync, and/or reset settings instead. This is done
via the effect's LFO Type parameter; select Individual to
use the effect's settings, or Common 1 or 2 to use the
Common LFOs.
8–9a: Common FX LFO1
Ch (Control Channel)
Specifies the MIDI channel that will control dynamic
modulation (Dmod) for Common LFO 1 and 2.
G ch: The global MIDI channel (GLOBAL 1–1a) will be
used for control. This is the default setting.
Sync (Reset)
Source (Dmod Source)
Frequency
MIDI/Tempo Sync
BPM
[ , 3 , , 3 , , 3 , , 3 , , ]
Base Note
Times
These parameters are the same as in PROGRAM mode. For
more information, please see "8–9a: Common FX LFO1" on
page 105.
[Ch01...Ch16, Gch]
[Off, On]
[List of Dmod Sources]
[0.02...20.00 (Hz)]
[Off, On]
[MIDI, 40.00...300.00]
[01...32]
SEQUENCER > IFX 8–9: Common FX LFO
8–9b: Common FX LFO2
These parameters are the same as for Common FX LFO1.
For more information, please see "8–9a: Common FX
LFO1," above.
v 8–9: Page Menu Commands
• Compare →p.112
• Memory Status →p.521
• Exclusive Solo →p.113
• Copy Insert Effect →p.122
• Swap Insert Effect →p.122
• Put Effect Setting to Track →p.554
• FF/REW Speed →p.523
• Set Location (for Locate Key) →p.523
• PAGE →p.126
• MODE →p.126
8–9PMC
517