Table of Contents
Advertisement
EQ
Treble
This adjusts the high frequency range of the amp.
Mid
This adjusts the mid-frequency range of the amp.
197: Rotary Speaker Pro CX Custom
This effect models a vintage rotary speaker, with detailed
control over both timbre and behavior. It provides the same
performance as the Rotary Speaker included in the updated
CX-3. For more information, see "7–2: Rotary Speaker" on
page 199.
If you're layering two CX-3s together, you may wish to
route both Programs through a single instance of this effect
instead of using the Rotary Speakers within the individual
Programs.
Rotary Speaker speed indicator
In PROGRAM, COMBINATION, SEQUENCER, and SET
LIST modes, if there is an active Rotary Speaker, its current
state (Fast, Slow, or Stop) is shown at the top of the display.
For more information, see "Rotary Speaker speed indicator"
on page 828.
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
Left
Horn
Rotary Speaker
+
Rotor
Right
D
-mod
Mode Switch: Rotate/Stop
D
-mod
Speed Switch: Slow/Fast
CONTROL
Mode Switch
This lets you stop the motion of the Rotary Speaker. Even
when stopped, the speaker will still affect the timbre.
The horn and rotor can each take different amounts of time
to start and stop their rotation. For more information, see the
Start Acceleration and Stop Deceleration parameters under
"HORN," below.
Source
This selects a modulation source to start and stop the Rotary
Speaker.
Mode
This determines the behavior of the Mode Switch. For more
information, see "Mode" on page 829.
Speed Switch
Switches the speaker rotation speed between slow and fast
Source
Selects a modulation source for Slow/Fast.
[-10...+10]
[-10...+10]
Wet / Dry
Mic Distance
Horn/Rotor
Balance
Mic Spread
Speaker Simulation
Wet / Dry
[Rotate, Stop]
[Off...Tempo]
[Toggle, Moment]
[Slow, Fast]
[Off...Tempo]
Vintage 197: Rotary Speaker Pro CX Custom
Bass
This adjusts the low frequency range of the amp.
OUTPUT
This is the standard effects output section, with modulatable
control over wet/dry balance. For more information, see
"OUTPUT" on page 762.
Mode
This determines the behavior of the Speed Switch. For more
information, see "Mode" on page 829.
Fast Overrides Stop
On (checked): setting the Speed Switch to Fast will make
the rotors speed up, even if the Mode Switch is set to Stop.
Off (un-checked): if the Mode Switch is set to Stop, the
rotors will always stay stopped, regardless of the Speed
Switch.
Fast Override Stop: Off
Stop
Rotate
Slow
Slow
Slow
Stop
Stop
Rotate
Fast
Fast
Fast
Speed Switch
Mode Switch
Horn Stop Phase [degrees]
When the Mode Switch is set to Stop, the Horn gradually
comes to rest pointing one way or another. This allows you
to control where it will stop.
Free lets it come to rest naturally, at a more or less random
spot. The other settings, –180 to +180, let you force it to land
in a specific position.
The speaker position has a dramatic effect on the tone, so
specifying a fixed position allows you to achieve consistent
timbral results.
Rotor Stop Phase [degrees]
This determines where the Rotor will land when the Mode
Switch is set to Stop. For more details, see "Horn Stop Phase
[degrees]," above.
[-10...+10]
[Toggle, Moment]
[Check-box]
Fast Override Stop
Fast Override Stop: On
Stop
Rotate
Slow
Slow
Stop
Slow
Stop
Rotate
Fast
Fast
Fast
[Free, –180...+180]
[Free, –180...+180]
897
Advertisement
Table of Contents
