Table of Contents
Advertisement
8–5: Insert FX
8–5a
8–5a: IFX
Here you can choose effects for each of the 12 inserts, turn
them on and off, configure chaining, and adjust the post-IFX
mixer settings. Meters below the IFX labels display the
effect output levels in realtime, showing the combined peak
signals of the left and right channels.
For insert effects, the direct sound (Dry) is always stereo-in
and out. The input/output configuration of the effect sound
(Wet) depends on the effect type. For more information,
please see "Insert Effects (IFX1...IFX12)" on page 737.
IFX1
IFX1
This selects the effect type for insert effect 1.
The meter below the label displays the effect's output level
in realtime, showing the combined peak signals of the left
and right channels.
Category/IFX Select menu
When you press the popup button, the Category/IFX Select
menu will appear, letting you select effects by category.
Use the tabs to select a category, and then select an effect
within that category. Press the OK button to execute your
selection, or press the Cancel button to cancel.
You can also use the Find button to search for effects by
name. For more information, see "Find dialog" on page 7.
IFX1 On/Off
Switches the insert effect on/off. The setting will alternate
between on and off each time you press the button.
If this is off, the input will simply be passed to the output.
(When 000:No Effect is selected, there's no audible
difference between On and Off.) Note, however, that even
when this is set to Off, the effect will continue to use
processing power.
Separately from this setting, you can use MIDI CC #92
(on the global MIDI Channel) to turn all insert effects
off. A value of 0 turns them off, and values of 1–127
[000...197]
restore the original setting.
Chain to
You can chain up to twelve insert effects together in series,
to create more complex effects. Set up the chain using this
parameter, and then enable it using the Chain check box,
below.
Effects must be chained in ascending numeric order. For
example, IFX1 can be chained to any of IFX2 through
IFX12, and IFX2 can be chained to IFX3 through IFX12.
You can chain two or more effects into the same down-
stream effect. For instance, both IFX1 and IFX2 can be
chained to IFX6.
Effects can also join a chain in the middle. For instance, you
can chain IFX3 to IFX4 to IFX9, and then chain IFX2 to
IFX9 as well.
The Pan (CC#8), Bus Select, REC Bus, and Send1/2
settings apply only to the last effect in the chain. However,
any effect in the chain can be sent to the FX Control buses.
Chain
This enables the chain, as set up by the Chain to parameter,
above.
PROGRAM > IFX 8–5: Insert FX
8–5PMC
[Off, On]
[IFX2...IFX12]
[Off, On]
101
Advertisement
Table of Contents
