Korg NAUTILUS Series Parameter Manual page 608

Hide thumbs Also See for NAUTILUS Series:
Table of Contents

Advertisement

SAMPLING mode
1...4: The signal will be output in monaural to the selected
AUDIO OUTPUT (INDIVIDUAL).
1/2...3/4: The signal will be panned by the "Pan (CC#8)"
setting and sent in stereo to the selected AUDIO OUTPUT
(INDIVIDUAL) pair.
Off: The signal will not be sent directly to the L/R or
Individual buses. Use this setting if you want to apply Send1
and Send2 and then send the signal directly to the master
effects.
FX Control Bus
Sends the post-IFX signal to the FX Control buses. See "8–
1d: REC Bus" on page 596.
REC Bus
Sends the post-IFX signal to the REC buses. See "8–1d:
REC Bus" on page 596. If you want to resample via the REC
buses, set Source Bus (0–8c) to REC 1/2 or REC 3/4.
Send1
Send2
These adjust the level at which the post-IFX signal is sent to
master effects 1 and 2. This is valid if Bus Select (8–5a) is
set to L/R or Off.
You can use CC#93 to control the Send 1 level, and
CC#91 to control the Send 2 level. The global MIDI
channel specified by MIDI Channel is used for these
messages.
IFX2...12
Here you can specify each insert effect's effect type, on/off
status, chaining, and mixer settings following the insert
effect. With the exception of Chain to and Chain, the
parameters are the same as for IFX1. See "IFX1" on
page 597.
IFX2: Chain to
IFX3: Chain to
IFX4: Chain to
IFX5: Chain to
IFX6: Chain to
IFX7: Chain to
IFX8: Chain to
IFX9: Chain to
IFX10: Chain to
IFX11: Chain to
These specify the chain destination for each insert effect. If
Chain (check box) is on, the insert effect will be connected
in series to the IFX specified by the Chain to setting.
8–5b: Tempo
(Tempo)
This specifies the tempo. This setting is used for controlling
effects, etc.
598
[Off, 1, 2]
[Off, 1...4, 1/2, 3/4]
[000...127]
[000...127]
[IFX3...IFX12]
[IFX4...IFX12]
[IFX5...IFX12]
[IFX6...IFX12]
[IFX7...IFX12]
[IFX8...IFX12]
[IFX9...IFX12]
[IFX10...IFX12]
[IFX11...IFX12]
[(IFX12)]
[040.00...300.00, EXT]
v 8–5: Page Menu Commands
• Copy Insert Effect →p.122
• Swap Insert Effect →p.122
• Insert IFX Slot →p.122
• Cut IFX Slot →p.123
• Clean Up IFX Routings →p.124
• PAGE →p.126
• MODE →p.126

Advertisement

Table of Contents
loading

This manual is also suitable for:

Nautilus-61

Table of Contents