009: Stereo Gate - Korg NAUTILUS Series Parameter Manual

009: Stereo Gate

On-screen graphic, 009 Stereo Gate
This effect mutes the input signal when it falls below a
specified level. You can also invert the on/off status of the
gate, or use note-on/off messages to turn the gate on/off
directly.
Stereo In - Stereo Out
Left
Envelope Source
Side PEQ
+
Envelope Select
D -mod
Right
FX Control BUS 1
FX Control BUS 2
ENVELOPE
Source [Dmod, Input, FX Control 1, FX Control 2]
Selects the source to control the gate: Dmod control, or use
the input signal or FX Control Bus 1 or 2 as a trigger. See
"Source" on page 762.
Dmod Control
Selects the source that will control the gate when Envelope
Source = Dmod.
Select
Selects the control signal: left and right linked, left only, or
right only. See "Select" on page 763.
Fx Control Trim
This adjusts the level of the FX Control Bus inputs.
Side Chain Monitor
Switches between monitoring the effect output and the
trigger signal. For more information, see "Side Chain
Monitor" on page 768.
SIDE CHAIN EQ
This band of fully parametric EQ applies only to the control
signal, and not to the main audio path. Use it to alter the
response of the limiter so that it reacts (or does not react)
only to specific frequencies. Its parameters are identical to
those in the Stereo Limiter; for more information, see "SIDE
CHAIN EQ" on page 768.
772
The red mark shows the Threshold setting.
Gain Adjust
Delay Gate
Envelope - Control
Trigger Monitor
Envelope - Control
Delay Gate
Gain Adjust
[Off...Tempo]
[L/R Mix, L Only, R Only]
[Check-box]
These lights show the relation of the control input to the
Threshold, in real-time.
Under (green) means the input is below the Threshold, and
Over (red) means that it is above the Threshold. Going above
the Threshold may make the gate open or close, depending
on the Polarity setting.
GATE
Threshold
Sets the level at which gating is applied.
Note that this does not apply when the ENVELOPE Source
is set to Dmod.
Wet / Dry
Output Level
Wet / Dry
Attack
Sets the attack time.
Release
Sets the release time.
Dry
[0...100]
Wet
Wet
Delay Time [msec]
This sets the delay time for the input to the gate. When using
shorter Attack Time settings, you can lengthen the Delay
Time so that the sound is input after the gate opens.
Polarity
This controls the way that the gate opens and closes in
response to the input signal.
Threshold
Louder
Input Level
Attack Release
[0...100]
Gate - Threshold
[1...100]
[1...100]
Gate - Attack / Release
Threshold
Attack=1
Release=1
Attack=100
Release=100
[0...100]
[+, –]