Table of Contents
Advertisement
054: Bi Phaser
This effect provides two independent phasers that can be
connected in series or in parallel.
Wet: Mono In - Stereo Out / Dry: Stereo In -Stereo Out
Left
Resonance
+
Dual
Mode
Serial
LFO1
Phase Lock
LFO2
Resonance
Right
PHASER1
Manual
Sets the frequency of phaser 1.
LFO1 Depth
Sets the LFO modulation depth of phaser 1.
Source
Selects a source to control LFO modulation depth of both
phasers.
Amount
Sets the amount by which the phaser 1 LFO modulation
depth will be controlled.
Resonance
This controls the intensity of Phaser 1. For more
information, see "Resonance" on page 808.
PHASER2
Manual
Sets the frequency of phaser 2.
LFO2 Depth
Sets the LFO modulation depth of phaser 2.
Amount
Sets the amount by which the phaser 2 LFO modulation
depth will be controlled.
Resonance
This controls the intensity of Phaser 1. For more
information, see "Resonance" on page 808.
LFO1/2
These are the parameters for the two LFOs, which are
identical to those in the Bi Chorus effect. For more
information, see "LFO1/2" on page 803.
Wet / Dry
Output Level1
Phaser
+
Output Mode
Phaser
Output Level2
Wet / Dry
[0...100]
[0...100]
[Off...Tempo]
[+/–100]
[0...100]
[0...100]
[0...100]
[+/–100]
[0...100]
Chorus, Flanger, and Phaser 054: Bi Phaser
MODE
Routing
Selects whether the phasers are connected in parallel or in
series. If Routing is set to Serial, the Phaser 1 Output
Level and Phaser 2 Output Level settings are ignored.
Output Mode
Selects whether phaser 1 and 2 will be routed separately to
the left and right channels, or summed to mono.
Routing: Dual
Routing: Dual
Output Mode: Mono
Output Mode: Stereo
Output Level1/2
Output Level1/2
Phaser1 Output Level
Sets the output level for phaser 1. This applies only if
Routing is set to Dual.
Phaser2 Output Level
Sets the output level for phaser 2. This applies only if
Routing is set to Dual.
OUTPUT
Wet/Dry
[–Wet...–1:99, Dry, 1: 99...Wet]
Sets the balance between the "wet" processed sound and the
dry input. Negative values invert the phase of the wet signal.
This interacts with Resonance; for more information, see
"Resonance" on page 808.
Source
Selects a modulation source for Wet/Dry.
Amount
Sets the modulation amount for Wet/Dry.
[Dual, Serial]
[Mono, Stereo]
Routing / Output Mode / Output Level 1/2
Routing: Serial
[0...100]
[0...100]
[Off...Tempo]
[+/–100]
811
Advertisement
Table of Contents
