Quick Split; Combination Settings Made By Quick Layer/Split - Korg KROSS Operation Manual

Playing and editing Programs

Quick Split

A typical example of a split is when you play a piano or
electric piano with your right hand (in the upper region) and
a bass sound with your left hand (in the lower region). As an
example, here's how to create this sound.
1. In Program mode, select a piano program.
Please see steps 1–2 of the "Quick Layer" section on
page 25.
Note: The procedure will be smoother if you first select
the sound that you want to play in the upper region of the
keyboard.
2. Press the SPLIT button. (The button blinks.)
The QUICK SPLIT dialog box will appear. Play the
keyboard, and you'll hear the split sound.
3. Select the other program (bass) that will be split with
the program you selected in step 2; then specify its
volume and pitch.
• Program:
Select the other program. If you used the CATEGORY
dial and the SELECT dial, press the MENU button to
close the list.
(Default setting: category BASS, index number 000)
• Split Point:
Specify the point at which the two programs will be
divided. When you play the keyboard, you'll hear the
bass in the lower region and the piano in the upper region
(including C4). (Default setting C4)
Note: You can use the keyboard to specify the split point.
Select this parameter, and press the ENTER button so that
the ▲▼ symbols are shown beside the value. Press a key
on the keyboard to enter the note number. Press the
ENTER button once again to confirm the setting.
• Lower/Upper:
If you select this parameter and press the ENTER button,
the two sounds will be exchanged. (Default setting:
Lower)
• Volume:
• Octave:
• Use ARP:
Please see step 4 of the "Quick Layer" section on
page 25.
Note: You can't change the settings of the first program.
Note: The next time you open this dialog box, the last-
specified settings will be selected as the default.
4. When you've finished adjusting settings, press the
WRITE (MENU) button to open the dialog box,
adjust the appropriate settings, and save them.
Please see steps 6 and 7 of "Quick Layer" on page 25.
26
Combination settings made by Quick
Layer/Split
When you use the Quick Layer or Quick Split function, the
effects, Drum Track, and step sequencer will be assigned to
the combination as follows.
The program that had been selected prior to pressing
the LAYER or SPLIT button
Program: copied to T01
Drum Track: copied to T10
Step sequencer: copied to T16
Arpeggiator: copied to Arp A
IFX1, IFX2, IFX5: copied to IFX1, IFX2, and IFX5
However, depending on the effect types and routing settings,
some effects will not be copied.
MFX1, MFX2: copied to MFX1 and MFX2
The program that was subsequently selected for
layer/split
Program: copied to T02
Drum Track: not copied
Step sequencer: not copied
Arpeggiator: if Use ARP is selected, copied to Arp B
IFX1, IFX2: copied to IFX3 and IFX4
However, depending on the effect types and routing settings,
some effects will not be copied.
MFX1, MFX2: not copied