Table of Contents
Advertisement
Copy X-Y Envelope
Copy X-Y Envelope is available on the X-Y Envelope tab
of the EQ/X-Y/Controllers page.
This command copies the X-Y envelope from a specified
program, combination/timbre, or song. For more
information, see "Copy X-Y Envelope" on page 119.
Detune BPM Adjust
Detune BPM Adjust is available on the Pitch tab of the
Timbre Parameters page.
This command changes a loop's tempo by changing the
Timbre's Detune parameter. The sample data itself is not
altered. Since this alters the pitch of the loop along with the
tempo, it's generally suited only to un-pitched percussive
loops.
Note: Using Detune BPM Adjust will over-write any
previous Detune settings.
1. Go to the Pitch tab of the Timbre Parameters page.
2. Select the Detune parameter for the desired Timbre.
Detune BPM Adjust is available only when the Detune
parameter has been selected. Otherwise, the menu selection
will be grayed out.
3. Select "Detune BPM Adjust" to open the dialog box.
4. In From, specify the loop's original BPM value.
Ignore any previous changes from using Detune BPM adjust.
5. In To, specify the desired BPM value.
The appropriate Detune value will be calculated
automatically from these two values.
For example, if you set "From" to 60 bpm and "To" to 120
bpm, Detune will be set to +1200 (one octave up).
6. To execute the Detune BPM Adjust command, press
the OK button. To exit without changing the Detune
value, press the Cancel button.
Note: Since this command does not affect the sample data
itself, and always over-writes the previous Detune amount,
using it repeatedly has no cumulative effect.
COMBINATION: Page Menu Commands Copy X-Y Envelope
Copy External Scene
Please see "Copy External Scene" on page 121.
Copy Scene
Please see "Copy Scene" on page 121.
Swap Scene
Please see "Swap Scene" on page 122.
Copy Insert Effect
This command copies effects settings from Program,
Combination, Song, or SAMPLING modes. For more
information, please see "Copy Insert Effect" on page 122.
Note: The slot's MIDI control channel, as specified by the
Ch parameter on the IFX1–12 pages, will not be copied.
Swap Insert Effect
This command swaps (exchanges) insert effect settings. For
more information, please see "Swap Insert Effect" on
page 122.
Note: The slot's MIDI control channel, as specified by the
Ch parameter on the IFX– IFX1-12 pages, will not be
swapped.
Insert IFX Slot
For more information, please see "Insert IFX Slot" on
page 122.
Cut IFX Slot
For more information, please see "Cut IFX Slot" on
page 123.
Clean Up IFX Routings
For more information, please see "Clean Up IFX Routings"
on page 124.
Drum Kit IFX Patch
This patches the Bus Select settings for each key of a drum
kit, temporarily changing the insert effect connection
destinations. You can execute this only if the timbre's
program is a drum program, "DKit" is checked, and the Bus
Select (GLOBAL 5–3b) setting of the keys in the drum kit is
set to either IFX1–12.
1. In the Routing1 page or Routing2 page, select the
timbre for which you want to make settings. (Select a
timbre parameter or Timbre Number.)
2. Select Drum Kit IFX Patch to open the dialog box.
437
Advertisement
Table of Contents
