Table of Contents
Advertisement
SEQUENCER mode
• Copy From Song →p.522
• Load Template Song →p.522
• Save Template Song →p.523
• FF/REW Speed →p.523
• Set Location (for Locate Key) →p.523
• GM Initialize →p.523
• Copy from Combi →p.525
0–8: Sampling
0–1a
0–8a
0–8b
Here you can adjust the settings for the analog/digital audio
signal input (AUDIO INPUT, USB), and the sampling-
related settings for SEQUENCER mode.
In SEQUENCER mode, the external audio sources you
specify here can be recorded to audio tracks or sampled.
(You can also record or sample a song that's played back by
the NAUTILUS or your own playing on the keyboard.) You
can also use the NAUTILUS as a 4-in/6-out effect processor.
You can't record a Song or pattern while sampling. Nor
can you sample while recording a Song or pattern.
462
• Copy From Program →p.525
• Copy Scene →p.121
• Swap Scene →p.122
• Add To Set List →p.113
• Initialize Scene →p.122
• PAGE →p.126
• MODE →p.126
0–8a: Sampling Setup
Here you can select the source to be sampled, and the
method by which to initiate sampling.
Except for Trigger, the following parameters are the same as
in the PROGRAM > Home– Sampling - Sampling Setup
page. For more information, see "0–8a: Sampling Setup" on
page 22.
Sampling Setup settings are maintained not separately for
each song, but as a single set in SEQUENCER mode.
Source Bus [Audio Input1/2, USB 1/2, L/R, REC1/2,
REC3/4, Indiv.1/2, Indiv.3/4]
Source Direct Solo
Sample to Disk
Save to
Sample Mode
Sample Time
Trigger
[Sampling START button, Note On,
Threshold, Sequencer START button]
Specifies how sampling will be initiated.
0–8PMC
0–8c
[Off, On]
[16-bit, 24-bit]
[RAM, Disk]
[L-Mono, R-Mono, Stereo]
[min] [sec]
Advertisement
Table of Contents
