072: Pitch Shift Mod - Korg NAUTILUS Series Parameter Manual

072: Pitch Shift Mod.

This effect uses an LFO to modulate the pitch shift amount,
and lets you adjust the panning and stereo width between the
effected and dry sounds.
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
Left
+
Pitch Shifter
Right
LFO: Tri / Sqr
PITCH SHIFTER
Pitch Shift [cents]
Sets the pitch difference from the input signal.
Depth
Sets the LFO modulation depth for pitch shift amount.
Pitch
Original Pitch
Source
Selects the modulation source of the depth of modulation.
Amount
Sets the modulation amount of the depth of modulation.
Pan
This simultaneously controls the panning and stereo width
for the pitch-shifted and dry sounds. The value is shown for
the pitch-shifted signal, and the dry signal is always at the
opposite side of the stereo field.
For instance, when Pan is set to L, the effected sound is
panned all the way to the left, and the dry sound is panned all
the way to the right. When Pan is set to R, the panning is
reversed.
Intermediate values decrease the stereo width, so that at
50:50, both sounds are centered.
LFO
Waveform
Selects the LFO Waveform.
Frequency [Hz]
Sets the LFO speed, in Hz.
Source
Selects a modulation source for LFO speed.
Wet / Dry
Pan
Wet / Dry
[+/–100]
[+/–100]
Pitch Shift Mod - Pitch Shift / Depth
LFO Waveform=Triangle
Depth (+value)
Pitch Shift (+ value)
LFO Waveform=Square
Depth (–value)
[Off...Tempo]
[+/–100]
[L, 1:99...99:1, R]
[Triangle, Square]
[0.02...20.00]
[Off...Tempo]
Modulation and Pitch Shift 072: Pitch Shift Mod.
Amount
Sets the modulation amount of LFO speed.
MIDI/Tempo Sync
BPM
Base Note
Times
When MIDI/Tempo Sync is on, the LFO speed is set by
BPM, Base Note, and Times, instead of Frequency. For
more information, see "MIDI/Tempo Sync" on page 779.
LFO Type [Individual, Common1, Common2]
Selects either (individual) LFO, Common FX LFO1, or
Common LFO2. p.779.
Common LFO Phase Offset [degrees]
Sets the phase offset when Type = Common 1 or Common 2.
p.779.
OUTPUT
Wet/Dry
Sets the balance between the effect and the dry input. Unlike
most effects, when this is set to Wet, the dry and effected
signals will be heard at equal volume.
Source
Selects a modulation source for Wet/Dry.
Amount
Sets the modulation amount for Wet/Dry.
[–20.00...+20.00]
[Check-box]
[MIDI, 40.00...300.00]
[ ... ]
[x1...x32]
[+/–180]
[Dry, 1:99...99:1, Wet]
[Off...Tempo]
[+/–100]
827