Siemens SINUMERIK 802S Diagnostics Manual page 98

1 Alarms
No./Name
14. FASTLIFTOFF
15. TM_MOVETOOL
16. DELDISTOGO
17. FASTDELDISTOGO
18. DELDISTOGOWITHOUT_STOP
19. PROGRESETREPEAT
20. PROGCANCELSUB
21. SINGLEBLOCKSTOP
22. SINGLEBLOCKOFF
23. SINGLEBLOCK_IPO
24. SINGLEBLOCK_
DECODIER
1-98
Explanation
Carry out quick
lifting
(VDI signal:
digital-analog
interface and
ASUP interface,
further actions
are: 11, 12, 13,
88, 89).
Move tool
- with tool man-
agement only -
(PI command)
Carry out "Delete 1. too high nesting depth
distance to go" 2. the current block in which program
(VDI signal: execution is stopped cannot be
Delete distance reorganized, since deceleration is
to go, synchro- carried out over several blocks.
nous response)
Carry out "Delete
distance to go
quickly". Block
execution is not
reorganized (VDI
signal: Delete
distance to go,
synchronous
response)
Carry out "Delete
distance to go
quickly". Reor-
ganization and
stop movement
are not carried
out.
(VDI signal:
Delete distance
to go, synchro-
nous response)
Abort subroutine 1. too high nesting depth
repetition (VDI 2. the current block in which program
signal: Delete execution is stopped cannot be
number of reorganized, since deceleration is
subroutine carried out over several blocks.
passes)
Abort subroutine 3. too high nesting depth
execution (VDI 4. the current block in which program
signal: program execution is stopped cannot be
level abortion) reorganized, since deceleration is
carried out over several blocks.
Activate single
block
(VDI signal:
Activate single
block)
Switch off single
block.
(VDI signal:
Activate single
block)
Activate main run
single block
(BTSS variable
and VDI signal:
Activate single
block)
Activate decod- 1. too high nesting depth
ing single block
(BTSS variable 2. the current block in which program
and VDI signal: execution is stopped cannot be
Activate single reorganized, since deceleration is
block) carried out over several blocks.
6FC5598-3AA20-0BP2
Not allowed if
⇒ Abort program
⇒ Abort program
⇒ Abort program
⇒ Abort program
⇒ Abort program
⇒ Abort program
⇒ Wait until the preceding Asup
⇒ Abort program
© Siemens AG 2002 All Rights Reserved
SINUMERIK 802S/802C (DG)
01.02
Remedy
is completed, or abort pro-
gram