Siemens SINUMERIK 802S Diagnostics Manual page 61

01.02
16 907
Explanation
Response
Remedy
Program continua-
tion by
16 908
Explanation
Response
Remedy
Program continua-
tion by
16 909
Explanation
Response
Remedy
Program continua-
tion by
16 911
Explanation
Response
Remedy
Program continua-
tion by
16 912
Explanation
Response
Remedy
© Siemens AG 2002 All Rights Reserved
SINUMERIK 802S/802C (DG)
Channel %1 action %2 only possible in stop
%1 = Channel number
%2 = Action number/action name (see Section 1.4 Action List)
The action may only be carried out in Stop condition.
Alarm display.
Check program state and channel state.
Press the Clear key to clear the alarm. No further operation required.
Channel %1 action %2 only possible in reset or at the block end
%1 = Channel number
%2 = Action number/action name (see Section 1.4 Action List)
Action %2 may only be carried out in reset state or at block end.
Alarm display.
Check program state and channel state.
Press the Clear key to clear the alarm. No further operation required.
Channel %1 the action %2 is not allowed in current mode
%1 = Channel number
%2 = Action number/action name (see Section 1.4 Action List)
Another mode must be activated for the activated function.
Alarm display.
Check operation and operating mode.
Press the Clear key to clear the alarm. No further operation required.
Channel %1 mode change is not allowed
%1 = Channel number
Changing from Overstore to another operating mode is not allowed. The 2nd
parameter specified describes the recommended operating mode to be selected.
Alarm display.
After you have quitted the Overstore mode, you can change to another mode.
Press the Clear key to clear the alarm. No further operation required.
Channel %1 program control: action %2 only possible in reset
%1 = Channel number
%2 = Action number/action name (see Section 1.4 Action List)
This action can only be carried out in Reset condition.
Alarm display.
Press Reset or wait until processing is completed.
6FC5598-3AA20-0BP2
1 Alarms
1-61