Siemens SINUMERIK 802S Diagnostics Manual page 21

01.02
10 225
Explanation
Response
Remedy
Program continua-
tion by
10 600
Explanation
Response
Remedy
Program continua-
tion by
10 601
Explanation
Response
Remedy
Program continua-
tion by
© Siemens AG 2002 All Rights Reserved
SINUMERIK 802S/802C (DG)
Channel %1: command % 2 refused
%1 = Channel number
%2 = String (event name)
The channel contained a command which cannot be executed.
Alarm display.
Press RESET.
Press the Clear key to clear the alarm. No further operation required.
Channel %1 block %2 auxiliary function during thread cutting active
%1 = Channel number
%2 = Block number, label
An auxiliary function output is programmed in a thread block.
Alarm display.
Subsequent error might occur if the machining path of the thread block is too
short and further blocks (thread blocks) follow in which no machining stop
may occur.
Possible remedial actions:
•
Program longer path and/or reduce traversing speed.
•
Output auxiliary function in another block (program section).
Press the Clear key to clear the alarm. No further operation required.
Channel %1 block %2 zero-velocity at end point during thread cutting
%1 = Channel number
%2 = Block number, label
This alarm occurs only if several blocks with G33 follow one after another.
The block end velocity in the specified block is zero although still one more
velocity block follows. Possible causes are, for example:
G09
Auxiliary function after movement
Output of auxiliary function prior to the movement of the subsequent block
Alarm display.
Interface signals are set.
Interpreter stop.
NC Start inhibited.
Modify NC part program (do not program "Stop at block end" G09)
Press the RESET key to clear the alarm. Restart part program.
6FC5598-3AA20-0BP2
1 Alarms
1-21