Siemens SINUMERIK 802S Diagnostics Manual page 58

1 Alarms
Remedy
Program continua-
tion by
16 740
Explanation
Response
Remedy
Program continua-
tion by
16 760
Explanation
Response
Remedy
Program continua-
tion by
16 762
Explanation
Response
Remedy
1-58
Program the thread lead under the appropriate Ipo (= interpolation) program.
Press the RESET key to clear the alarm. Restart part program.
Channel %1 block %2 geometry axis must be programmed
%1 = Channel number
%2 = Block number, label
No geometry axis has been programmed for thread cutting (G33).
However, the geometry axis is absolutely necessary when an interpolation
parameter was specified.
Alarm display.
Interface signals are set.
Interpreter stop.
NC Start inhibited.
Specify geometry axis and respective interpolation parameter.
Press the RESET key to clear the alarm. Restart part program.
Channel %1 block %2 axis %3 S value missing
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
The spindle speed for tapping without compensation chuck (G331 or G332)
has not been specified.
Alarm display.
Interface signals are set.
Interpreter stop.
NC Start inhibited.
Program spindle speed under address S in [rev/min] (despite of axis mode); the
direction of rotation results from the spindle lead.
positive thread lead:
negative thread lead:
Press the RESET key to clear the alarm. Restart part program.
Channel %1 block %2 spindle %3 function of thread or drill is active
%1 = Channel number
%2 = Block number, label
%3 = Spindle number
Faulty programming:
The spindle function cannot be executed at the moment.
The alarm occurs if the spindle is linked with axes via interpolation.
Alarm display.
Interface signals are set.
Interpreter stop.
NC Start inhibited.
Modify part program. Deselect thread cutting or tapping.
6FC5598-3AA20-0BP2
Direction of rotation as with M03
Direction of rotation as with M04
© Siemens AG 2002 All Rights Reserved
SINUMERIK 802S/802C (DG)
01.02