Siemens SINUMERIK 802S Diagnostics Manual page 90

1 Alarms
Remedy
Program continua-
tion by
61 106
Explanation
Response
Remedy
Program continua-
tion by
61 107
Explanation
Response
Remedy
Program continua-
tion by
61 108
Source (cycle)
Response
Remedy
Program continua-
tion by
61 109
Explanation
Response
Remedy
Program continua-
tion by
61 601
Source (Cycle)
Response
Remedy
1-90
The milling cutter radius in the tool offset memory is greater than the pocket or
groove width (R119 or R118).
Use smaller cutter or modify pocket width.
Press the RESET key to clear the alarm. Restart part program.
Number of or distance between circular elements
LCYC61
Block preparation in NC is aborted.
Faulty parameterization of R119 or R1220.
The arrangement of the circle elements on a full circle is not possible.
Press the RESET key to clear the alarm. Restart part program.
First drilling depth incorrectly defined
LCYC83.
Block preparation in NC is aborted
Modify value for the first drilling depth (first drilling depth is opposite to the
total drilling depth).
Press the RESET key to clear the alarm.
Wrong milling direction
LCYC75
Block preparation in NC is aborted
Faulty parameter R126.
This is greater than 3 or less than 2.
Press the RESET key to clear the alarm. Restart part program.
Parameterized cycle parameters incorrectly defined
LCYC60
LCYC61
Block preparation in NC is aborted.
Parameter R115 is faulty.
The parameterized cycle number is missing.
Press the RESET key to clear the alarm.
Restart part program.
Finished part diameter too small
LCYC94
Block preparation in NC is aborted
A finished-part diameter < 3mm has been programmed. Increase value.
6FC5598-3AA20-0BP2 © Siemens AG 2002 All Rights Reserved
SINUMERIK 802S/802C (DG)
01.02