Siemens SINUMERIK 802S Diagnostics Manual page 56

1 Alarms
Remedy
Program continua-
tion by
16 510
Explanation
Response
Remedy
Program continua-
tion by
16 700
Explanation
Response
Remedy
Program continua-
tion by
16 710
Explanation
Response
1-56
Use only positive values to program chamfers, roundings and modal roundings.
Press the RESET key to clear the alarm. Restart part program.
Channel %1 block %2 facing axis is not defined
%1 = Channel number
%2 = Block number, label
Diameter programming has been programmed without facing axis.
This function is not available for turning/milling.
Alarm display.
Interface signals are set.
Interpreter stop.
NC Start inhibited.
Remove diameter programming from the NC program.
Press the RESET key to clear the alarm. Restart part program.
Channel %1 block %2 axis %3 invalid feed type
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
The feed for a thread cutting function has been programmed with an invalid
unit.
1. G33 (thread with constant lead) and feed has not been programmed with
G94 or G95.
2. G33 (thread with constant lead) is active (maintained) and, in addition,
G63 is programmed in a following block → conflict! (G63 is in the 2nd,
G33 in the 1st group).
Alarm display.
Interface signals are set.
Interpreter stop.
NC Start inhibited.
Use only feed type G94 or G95 for thread cutting functions.
Use G01 to deselect the thread cutting function after G33 and in front of G63.
Press the RESET key to clear the alarm. Restart part program.
Channel %1 block %2 axis %3 master spindle not programmed
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
A master spindle function has been programmed (G33, G95, G96), without
programming the speed or the direction of rotation of the master spindle.
Alarm display.
Interface signals are set.
Interpreter stop.
NC Start inhibited.
6FC5598-3AA20-0BP2 © Siemens AG 2002 All Rights Reserved
SINUMERIK 802S/802C (DG)
01.02