Siemens SINUMERIK 802S Diagnostics Manual page 57

01.02
Remedy
Program continua-
tion by
16 715
Explanation
Response
Remedy
Program continua-
tion by
16 720
Explanation
Response
Remedy
Program continua-
tion by
16 730
Explanation
Response
© Siemens AG 2002 All Rights Reserved
SINUMERIK 802S/802C (DG)
Add S value or direction of rotation for the master spindle in the displayed
block.
Press the RESET key to clear the alarm. Restart part program.
Channel %1 block %2 axis %3 master spindle not in standstill
%1 = Channel number
%2 = Block number, label
%3 = Spindle number
The spindle must not move when the function is in use (G74, reference point
approach).
Alarm display.
Interface signals are set.
Interpreter stop.
NC Start inhibited.
Program M5 or SPOS in the part program in front of the faulty block.
Press the RESET key to clear the alarm. Restart part program.
Channel %1 block %2 axis %3 thread lead is zero
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
No lead has been programmed in a thread block with G33 (thread with con-
stant lead).
Alarm display.
Interface signals are set.
Interpreter stop.
NC Start inhibited.
The thread lead for the specified geometry axis must be programmed under the
associated interpolation parameter.
X I
Y J
Z K
Press the RESET key to clear the alarm. Restart part program.
Channel %1 block %2 axis %3 wrong parameter for thread cutting
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
During thread cutting with G33, the parameter has not been specified for the
velocity-defining axis (axis with the longest traversing path).
Alarm display.
Interface signals are set.
Interpreter stop.
NC Start inhibited.
6FC5598-3AA20-0BP2
1 Alarms
1-57