Siemens SINUMERIK 802S Diagnostics Manual page 102

1 Alarms
No./Name
67. PROGMODEDRYRUN
OFF
68. BLOCKREADINHIBIT_
ON
69. BLOCKREADINHIBIT_
OFF
70. STOPATEND_ALARM
71. STOP_ALARM
72. PROGESTON
73. PROGTESTOFF
74. STOPATIPOBUFFER_
ISEMPTY_ALARM
75. STOPATIPOBUF_
EMPTY_ALARM_
REORG
76. CONDITIONAL_STOP
ATEND
77. CONDITIONAL_SBL_
DEC_STOPATEND
78. INTERPRETERSTOP_
ALARM
79. RETREAT_MOVE_
THREAD
80. WAITMC
81. SETM
82. CLEARM
83. BLOCK_SELECT
1-102
Explanation Not allowed if
Deactivate test 1. too high nesting depth
run
(VDI signal:
Rapid traverse 2. the current block in which program
superimposition execution is stopped cannot be
l) reorganized, since deceleration is
carried out over several blocks.
Activate read-in
disable for main
run block (VDI
signal: Read-in
inhibit)
Deactivate read-
in disable for
main run block
(VDI signal:
Read-in inhibit)
Stop at end of
block (alarm)
Stop all axes
(alarm)
Activate program 1. tool management is active.
test 2. the NCK channel condition is not
(VDI signal: READY
Program test)
Deactivate NCK channel condition is not READY
program test
(VDI signal:
Program test)
Stop at end of
block preparation
(alarm)
Stop at end of nesting depth too high
block preparation
with following
reorganization of
block execution
(alarm)
Conditioned stop
at end of block (If
after continuation
by NC Start a
reason for stop
"Stop at end of
block" is still
provided, Stop is
carried out
again.)
Conditioned stop
at end of block
(Despite of start,
no block is
moved by the
interpreter or
advance to the
main run.)
Stop block
search (alarm)
Retraction
movement in the
case of G33 and
stop.
Conditioned
waiting for
program marker
(NC block:
WAITMC)
Set marker (NC
block: SETM)
Delete marker
(NC block:
CLEARM)
Select NC block
(PI command)
6FC5598-3AA20-0BP2
Remedy
⇒ Wait until the preceding
ASUP is completed, or abort
program
⇒ Abort program
⇒ Save tool data
⇒ Press RESET to abort pro-
gram or process, or wait for
end of program
⇒ Press RESET to abort pro-
gram or process, or wait for
end of program
⇒ Wait until preceding Asup is
completed, or abort program
© Siemens AG 2002 All Rights Reserved
SINUMERIK 802S/802C (DG)
01.02