Siemens SINUMERIK 802S Diagnostics Manual page 26

1 Alarms
10 753
Explanation
Response
Remedy
Program continua-
tion by
10 754
Response
Remedy
Program continua-
tion by
10 755
Explanation
1-26
Channel %1 block %2 activate tool radius compensation in linear block
only
%1 = Channel number
%2 = Block number, label
Tool radius compensation with G41/G42 may only be selected on blocks with
the G function G00 (rapid traverse) or G01 (feed) active.
The block with G41/G42 must contain at least one axis of the level G17 to
G19; always both axes are recommended, since both axes are traversed when
selecting the compensation.
Alarm display.
Interface signals are set.
NC Start inhibited.
Correct the NC program; replace the compensation selection to a block with
linear interpolation.
Press the RESET key to clear the alarm. Restart part program.
Channel %1 block %2 deactivate tool radius compensation in linear block
only
Explanation
%1 = Channel number
%2 = Block number, label
The deselection of the tool radius compensation by G40 may only be carried
out in blocks in which the G function G00 (rapid traverse) or G01 (feed) is
active.
The block with G40 must contain at least one axis of the plane G17 to G19;
both axes are always recommended, since usually both axes traverse when
deselecting the compensation.
Alarm display.
Interface signals are set.
NC Start inhibited.
Correct NC program; replace compensation deselection to a block with linear
interpolation.
Press the RESET key to clear the alarm. Restart part program.
Channel %1 block %2 do not activate tool radius compensation via
KONT at the current starting point
%1 = Channel number
%2 = Block number, label
When activating the cutter radius compensation via KONT, the start point of
the approach block is within the compensation circle, thus already violating the
contour.
6FC5598-3AA20-0BP2 © Siemens AG 2002 All Rights Reserved
SINUMERIK 802S/802C (DG)
01.02