Siemens SINUMERIK 802S Diagnostics Manual page 20

1 Alarms
8 040
Explanation
Response
Remedy
Program continua-
tion by
10 203
Explanation
Response
Remedy
Program continuation
by
10 208
Explanation
Response
Remedy
Program continua-
tion by
1-20
Machine data %1 reset, corresponding option is not set
%1 = String: MD identifier
An MD has been set which is locked by an option.
Alarm display.
To upgrade your CNC with the required option, contact either your machine
manufacturer or a sales engineer of AUT 2 of SIEMENS AG.
Press the Clear key to clear the alarm. No further operation required.
Channel %1 NC-start not possible with unreferenced axes (Cmd = %2).
%1 = Channel number
%2 = String (event name)
NC Start has been pressed either in MDA or AUTOMATIC mode, and at least
one axis to be referenced has not reached its reference point.
Alarm display.
Referencing start can be initiated either channel or axis-specifically.
1. Channel-specific reference-point approach: The rising edge of the
interface signal "Activate referencing" (V 32000001.0) starts an auto-
matic cycle which start the axes of the channel in the sequence of order
specified in the axis-specific MD 34 110 REFP_CYCLE_NR (axis order
for channel-specific referencing).
-1: Axis is not involved in channel-specific referencing, but must be
referenced for NC start.
0: Axis is not involved in channel-specific referencing, but must be
referenced for NC start
1-4: Starting sequence for channel-specific referencing (simultaneous
start with the same number.)
2. Axis-specific referencing: Press the direction key corresponding to the
approach direction specified in the axis-specific MD 34 010
REFP_CAM_DIR_IS_MINUS (Approach Reference Point in Minus
Direction).
Press NC START to clear the alarm and continue program execution.
Channel %1 Continue program with NC-Start
%1 = Channel number
After block search with calculation, the control system is in the desired state.
The program can now be started with NC Start or in the state first changed by
Overwrite/Jog.
Alarm display.
NC Stop at alarm.
Press NC Start.
Press NC START to clear the alarm and continue program execution.
6FC5598-3AA20-0BP2 © Siemens AG 2002 All Rights Reserved
SINUMERIK 802S/802C (DG)
01.02