Siemens SINUMERIK 802S Diagnostics Manual page 73

01.02
20 051
Explanation
Response
Remedy
Program continua-
tion by
20 055
Explanation
Response
Remedy
Program continua-
tion by
20 056
Explanation
Response
Remedy
Program continua-
tion by
20 057
Explanation
Response
© Siemens AG 2002 All Rights Reserved
SINUMERIK 802S/802C (DG)
Channel %1 axis %2 handwheel mode not possible
%1 = Channel number
%2 = Axis name, spindle number
The axis is already traversed via the direction keys; traversing via handwheel is
thus no longer possible.
Alarm display.
Decide whether you want to traverse the axis via the direction keys or via the
handwheel.
The alarm display disappears with the alarm cause. No further operation re-
quired.
Channel %1 Master spindle does not exist in JOG mode
%1 = Channel number
You wish to traverse at revolutional feedrate in the JOG mode, but there is no
master spindle.
Alarm display.
Interface signals are set.
Define the master spindle.
Press the cancel key to clear the alarm.
No further operation required.
JOG: Channel %1 axis %2 no revolutional feedrate possible. Axis/spindle
%3 stationary
%1 = Channel number
%2 = Axis name, spindle number
%3 = Axis name, spindle number
An axis is to be traversed in JOG mode with feedrate per revolution. However,
the feed of the spindle/axis from which the feed is to be derived is zero.
Alarm display.
The spindle/axis from which the feed is to be derived is to be traversed.
The alarm display disappears with the alarm cause. No further operation re-
quired.
Channel %1 block %3 Revolutional feedrate for axis/spindle %2 is <= 0
%1 = Channel number
%2 = Axis name, spindle number
%3 = Block number, label
Revolutional feedrate has been programmed for an axis/spindle, but no veloc-
ity/speed was specified, or the programmed value is less than zero.
Alarm display.
Interface signals are set.
6FC5598-3AA20-0BP2
1 Alarms
1-73