Siemens SINUMERIK 802S Diagnostics Manual page 37

01.02
12 140
Explanation
Response
Remedy
Program continua-
tion by
12 150
Explanation
Response
Remedy
Program continua-
tion by
12 160
Explanation
Response
Remedy
Program continua-
tion by
12 180
Explanation
© Siemens AG 2002 All Rights Reserved
SINUMERIK 802S/802C (DG)
Channel %1 block %2 expression %3 not contained in this release
%1 = Channel number
%2 = Block number, label
%3 = Software construct in source text
The full version of the control system provides functions which are not imple-
mented in the current variant.
Alarm display.
Interface signals are set.
Remove the displayed function from the program.
Press NC START to clear the alarm and continue program execution.
Channel %1 block %2 operation %3 not compatible with data type
%1 = Channel number
%2 = Block number, label
%3 = String (violating operator)
The data types are not compatible with the required operation (within an arith-
metic expression or a value assignment).
Alarm display.
Interface signals are set.
Modify the definition of the variables used such that the desired operations can
be carried out.
Press NC START to clear the alarm and continue program execution.
Channel %1 block %2 range of values exceeded
%1 = Channel number
%2 = Block number, label
The constant programmed for the variable exceeds the value range which has
been defined by the data type in advance.
Alarm display.
Interface signals are set.
Correct the value of the constant. If the value for an integer constant is too
large, it can also be specified by appending a decimal point as a real constant.
Example:
R1 = 9 876 543 210
Press NC START to clear the alarm and continue program execution.
Channel %1 block %2 illegal chaining of operators %3
%1 = Channel number
%2 = Block number, label
%3 = Chained operators
The term 'operator chaining' denotes binary and unary operators chained one
after another, without the use of brackets.
correct to: R1 = 9 876 543 210.
6FC5598-3AA20-0BP2
1 Alarms
1-37