Siemens SINUMERIK 802S Diagnostics Manual page 101

01.02
No./Name
51. NEWCONF
52. CLEARCANCELALARM
53. BLOCKSEARCHUN_
CONTINUE
54. BLOCKSEARCHRUN_
START
55. BLOCKSEARCHRUN_
RESUME
56. DIGITIZEON
57. DIGITIZEOFF
58. FUNCTGENON
59. FUNCTGENOFF
60. WAITM
61. WAITE
62. INIT_SYNC
63. MMC_CMD
64. PROGMODESLASHON
65. PROGMODESLASH
OFF
66. PROGMODEDRYRUN
ON
© Siemens AG 2002 All Rights Reserved
SINUMERIK 802S/802C (DG)
Explanation
Sets all machine
data with
(NEW_CONF)
attribute to active
state
(PI command)
Delete all alarms
with
CANCELCLEAR
clear condition
(PI command,
Quit Alarm key)
Continue block
search.
(NC block,
Stopre)
Start block
search.
(PI command)
Continue block
search
(PI command)
Activate digitali-
zation (PI com-
mand)
Deactivate
digitalization (PI
command)
Switch on func-
tion generator (PI
command)
Switch off func-
tion generator (PI
command)
Wait for program
marker (channel
communication,
NC block:
WAITM)
Wait for end of
program (channel
communication,
NC block:
WAITE)
Program selec-
tion from another
channel, syn-
chronization
(Channel com-
munication, NC
block: INIT)
Wait until ac-
knowledgment
from MMC (NC
block,
MMC_CMD)
Activate block sip too high nesting depth
of blocks that can
be skipped (VDI
signal: Skip
block)
Deactivate block too high nesting depth
skip of blocks
that can be
skipped (VDI
signal: Skip
block)
Activate test run 1.
too high nesting depth
(VDI signal:
Rapid traverse
superimposition)
2.
the current block in which program
execution is stopped cannot be
reorganized, since deceleration is
carried out over several blocks.
6FC5598-3AA20-0BP2
Not allowed if
⇒ Wait until the preceding
⇒ Wait until the preceding Asup
⇒ Wait until the preceding
⇒ Abort program
1 Alarms
Remedy
ASUP is completed, or abort
program
is completed, or abort pro-
gram
ASUP is completed, or abort
program
1-101