Siemens SINUMERIK 802S Diagnostics Manual page 34

1 Alarms
10 934
Explanation
Response
Remedy
Program continua-
tion by
12 000
Explanation
Response
Remedy
Program continua-
tion by
12 010
Explanation
Response
Remedy
Program continua-
tion by
12 050
Explanation
1-34
Channel %1 block %2 array for contour segmentation is too small
%1 = Channel number
%2 = Block number, label
The program in which the stock removal contour is programmed contains too
many blocks with movements in both axes in the machining plane (LCYC 95).
Alarm display.
Interface signals are set.
NC Start inhibited.
Reduce the number of blocks in the contour program. Check the division of the
contour into several programs.
Press the RESET key to clear the alarm. Restart part program.
Channel %1 block %2 address %3 programmed repeatedly
%1 = Channel number
%2 = Block number, label
%3 = Source string of address
Most addresses (address types) may be programmed in an NC block only once
so that the search information remains unambiguously.
(e.g. X.. T.. F.. etc. - Exception: G, M functions).
Alarm display.
Interface signals are set.
Correct block.
Press NC START to clear the alarm and continue program execution.
Channel %1 block %2 address %3 address type programmed too often
%1 = Channel number
%2 = Block number, label
%3 = Source string of address
It is defined for each address type how often it may occur in an NC block (for
example, all axes together form a address type, which is also subject to a block
limit).
Alarm display.
Interface signals are set.
Correct the block.
Press NC START to clear the alarm and continue program execution.
Channel %1 block %2 DIN-address %3 is not configured
%1 = Channel number
%2 = Block number, label
%3 = NC address in source text block
The name of the NC address (e.g. X, U, X1) is not defined in the control sys-
tem.
6FC5598-3AA20-0BP2 © Siemens AG 2002 All Rights Reserved
SINUMERIK 802S/802C (DG)
01.02