Starting Call Processing On The Lsps And Esss, If Any; Logging Off All Administration Applications - Avaya S8 Series Manual

Upgrading Communication Manager on the S8700-Series main or ESS servers from R2.x/R3.x/R4.x/R5.x to

Starting call processing on the LSPs and ESSs, if any

You must restart call processing on a local survivable processor (LSP) if both of the following
conditions are true:
The server is the primary controller for a G350 or G700 Media Gateway equipped with an
●
LSP.
You shut down the server before you upgraded the software.
●
!
Important:
You must be connected to the LSP on which you are upgrading the software.
Important:
You must also restart call processing on any Enterprise Survivable Server (ESS) on which you
stopped call processing before you upgraded software.
Perform the following administration when you connect your laptop to the primary controller
(server) with SSH.
1. Access the command line interface of the server with an SSH client like PuTTY and an IP
address of 192.11.13.6.
2. Type telnet IPaddress, where IPaddress is the IP address of the S8300 or S8500
LSP, or the S8500 or S8700-series ESS.
3. Log in as craft or dadmin.
4. At the prompt type start -afcn and press Enter to restart call processing on the LSP or
ESS.
5. Repeat for each LSP or ESS.
For more information, see:
- Installing and Upgrading the Avaya S8300 Server, 555-234-100.
- Installing and Upgrading the Avaya G700 Media Gateway, 03-603333.
- Using the Avaya Enterprise Survivable Server (ESS), 03-300428.

Logging off all administration applications

When you complete all the administration, log off all the applications that you used.
208 Upgrading Avaya Aura™ Communication Manager on Avaya S8xxx Servers