Table of Contents
Advertisement
Upgrading Communication Manager from 2.x, 3.x or 4.x to 5.x and replacing S8300B Server with an S8300C/
6. Remaster the hard drive and
install the software.
See Remastering the hard
drive and installing the
software in Chapter 12.
7. Install post-upgrade service
pack file.
See Installing security and
Communication Manager
service pack updates, if any in
Chapter 12.
8. Set time, date, and time zone.
See Setting the time, date, and
time zone in Chapter 12.
9. Restore all data to the server.
See Restoring all data in
Chapter 12.
10. Restore data backup.
See Restoring data backup in
Chapter 12.
11. Reboot the server
See Rebooting the Server in
Chapter 7.
62 Upgrading Avaya Aura™ Communication Manager on Avaya S8xxx Servers
Task
Steps/Comments
Set Telnet parameters
●
Remaster hard drive and install upgrade
●
software
ICC Mode: To use CMM (formerly known
●
as IA770), select yes on Run AUDIX
Installation screen
LSP Mode: Select No on Run AUDIX
●
Installation screen.
Verify software version
●
ICC Mode: The time zone of the new ICC must
be set, and all LSPs under the ICC's control must
be set to the new ICC's time zone.
LSP Mode: The time of the LSP must be set to
the same time zone as its primary controller,
even if the LSP is physically located in a different
time zone.
If you have not already done so, in the Record
Configuration Information task, record all of the
configuration information, regardless of the
release from which you are upgrading.
You will re-enter some of this information after the
upgrade.
Select the restore procedure according to the
release from which you upgraded.
ICC Mode: Restore Translations and
●
AUDIX files, if used.
LSP Mode: Restore operating system and
●
security files.
A server reboot (Shutdown with/restart)
should be done. Use the Shutdown Server link on
the System Management Interface (SMI).
3 of 6
Advertisement
Table of Contents
