Removing Power From The Server; Removing The Server From The Rack - Avaya S8 Series Manual

DAL: Removing or Installing

Removing power from the server

If the server is not powered up and installed in the rack, skip this procedure and go to
the cover from the server
!
CAUTION:
Ensure that you are connected to the standby server. Proceeding with the
CAUTION:
following steps and being connected to the incorrect server can result in service
disruption.
To shut down the server:
1. Under Server, click Shutdown Server.
2. Make the following selections:
Select Delayed Shutdown
●
Deselect Restart Server after Shutdown
●
3. Click Shutdown. Wait until the server has powered down.
4. When the server is powered down, disconnect the power cord from the server.

Removing the server from the rack

Skip this procedure if the server is not installed in a rack and go to
server on page 244.
!
DANGER:
The server weighs between 47-60 pounds (20-27 kg). Do not remove the server
DANGER:
from the rack by yourself.
To remove the server from the rack:
1. Label and remove all cables from the front and back panels of the server.
2. Release the two (2) locking clips on each side of the server (Note 1 in
from the
242 Upgrading Avaya Aura™ Communication Manager on Avaya S8xxx Servers
on page 244.
rack).
Removing
Removing the cover from the
Removing the server